Why is my Kenwood radio not working?

Why is my Kenwood radio not working? 

Blown Fuse

If the radio will not turn on, first check the fuse located on the back of the radio. If the fuse is burnt, replace with a fuse of the same amperage rating. The guide to replacing the fuse can be found here.

How do I get my Kenwood radio to work? 

You can set up the tuner.
  1. Select the Tuner source. Refer to <Source selection>.
  2. Press and hold the [AUDIO] button. Enter the Function setting mode.
  3. Use the [Control knob] to select “SETTINGS”.
  4. Use the [Control knob] to select a Tuner setting item.
  5. Use the [Control knob] to select a setting.

Why is my Kenwood radio flashing protect? 

Kenwood equips its receivers with a protection mode to safeguard them. Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.Jun 20, 2017

Does a Kenwood radio have a fuse? 

The fuse can be found on the back of your radio indicated by the red square in the photo.

Why is my Kenwood radio not working? – Related Questions

Why does my car stereo keep turning on and off?

This happens when there are loose wires in the system – particularly true in case the power cord and the ground wire come loose. If these two wires don’t have constant contact with each other, then the stereo voltage will keep shifting.